Five features of the main mixer with double horizontal shaft:

Safe and reliable without axle: Water pressure spraying is adopted inside the main engine to match the correct feeding sequence and landing point, so that the main engine does not axle, just clean the floating ash on the cover of the main engine. Reduce manual cleaning times, reduce labor intensity, reduce the accident rate.

Environmental protection: in addition, equipped with the main machine dust collector, with automatic dust collection, exhaust, dust collection to the main machine back to the function, dust collection effect is excellent, no pollution to the environment.

Large capacity: more capacity than other company brands, faster mixing speed.

Easy maintenance: The traditional grease pump has only one pressure gauge, so it is impossible to determine which bearing has problems; The new grease pump can know the lubrication condition of shaft end at any time and reduce the maintenance times of shaft head.

No leakage: the shaft head of the main engine is double sealed with oil and gas, which has better sealing effect and more reliable effect. The latest lubricating pump is adopted to know the state of the shaft end at any time.

Monitoring system: it can monitor the oil volume and temperature of the reducer casing. The discharge pump oil quantity and temperature can be monitored. The working state of lubricating oil pump can be monitored. It is equipped with a monitor and an alarm which can be installed in the operation room. When the operation state is out of order, the alarm will alarm automatically. Remote monitoring can be realized in the operation room.

Host distribution:

Centralized oil supply: Centralized oil supply is adopted for doumen shaft and bearing, which is convenient for maintenance.

Improved observation window: more waterproof.

Camera device: The installation of camera device makes the mixing effect in the main machine visible, easy to grasp the degree of collapse.

Pressurized water pump and ingenious waterway design: reduce the phenomenon of the main engine holding the shaft, so as to reduce the number of people entering the main engine, reduce the accident probability

Electric lubricating oil pump :1. It adopts 380V strong motor, which can quickly pump lubricating oil to shaft head through 4 high-pressure rubber pipes. 2. NRGL secondary or tertiary lubricating oil can be used to make shaft end seal with good sealing effect and more fuel saving; 3. Avoid frequent cleaning of shunt valve and reduce the workload of repair and maintenance.

Double safety lock: two safety locks guarantee the safety of operators entering the host

Unloading brake: 1. Adopting advanced hydraulic driving equipment, avoiding the failure of the mixer to unload due to insufficient pneumatics during the unloading of pneumatic door; 3. In case of power failure, manual discharging control can be enabled, which is safe and reliable.

Unloading door travel switch: can effectively control the unloading door fully open, half open, closed three states

Shaft end seal: 1. Two steel bearing protection rings are used between the left stirring arm and shaft head to prevent the coarse sand from entering. 2. An air passage is opened in the steel ring. When the air passage is provided with a certain pressure, an air pressure protection pad will be formed at the contact surface between the side mixing arm and the shaft head to keep the water and mud away from the shaft head and extend the service life of the mixer.

First layer: steel ring protection

Second layer: air seal protection

Layer 3: Special gasket seal protection

Fourth layer: concrete special seal ring

Strong and weak electric separate control: clear wiring, easy installation

Reducer: reducer and oil seal system are specially designed and produced by professional manufacturer for blender, which can work smoothly with blender, long service life, low noise and no oil leakage.

Part identification: clearer use instructions of product parts, easier to maintain products